LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2002 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Body Control Modules) >> Self-Diagnostic System >> Driver Information Center Diagnostic System Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Driver Information Center Diagnostic System Check

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect scan tool to Data Link Connector (DLC). DLC is located below driver side of instrument panel, near steering column. If scan tool powers up, go to next step. If scan tool does not power up, perform TEST A: SCAN TOOL DOES NOT POWER UP  under SYSTEM TESTS.
  2. Turn ignition switch to RUN position. Using scan tool, attempt to communicate with Driver Door Module (DDM), Dash Integration Module (DIM), Electronic Brake Control Module (EBCM), Instrument Panel Cluster (IPC), Powertrain Control Module (PCM), Rear Integration Module (RIM), Sensing and Diagnostic Module (SDM) and Theft Deterrent Controller (TDC) module. If scan tool communicates with DDM, DIM, EBCM, IPC, PCM, SDM and TDC module, go to next step. If scan tool does not communicate with DDM, DIM, EBCM, IPC, PCM, SDM and TDC module, perform TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE  under SYSTEM TESTS.
    3. CAUTION: Engine may start. Turn ignition switch to OFF position as soon as you have observed crank power mode.
  3. Using scan tool, access CLASS 2 POWER MODE. Cycle ignition switch through all positions while observing ignition switch power mode parameter. If ignition switch parameter matches ignition switch positions, go to next step. If ignition switch parameter does not match ignition switch positions, perform TEST C: POWER MODE MISMATCH  under SYSTEM TESTS.
  4. Using scan tool, select DISPLAY DTCs function for DDM, DIM, EBCM, IPC, PCM, SDM and TDC module. If scan tool displays any DTCs, go to next step. If scan tool does not display any DTCs, repair DIC system by symptom. See INSTRUMENT PANELS - AURORA article.
  5. If scan tool does not display any DTCs which begin with "U", perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . If scan tool displays any DTCs which begin with "U", perform TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE  under SYSTEM TESTS.
scientia non olet · About LEMON Manuals