Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Traction Control Switch Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors.
Push in on the switch bank in order to install the switch bank.

Fig 2: Removing/Installing Traction Control Switch Bolts/Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts/screws to the switch bank to instrument panel.
Tighten: Tighten the bolts/screws to 2.5 N.m (22 lb in).

Fig 3: View Of Instrument Panel Accessory Trim Plate

Courtesy of GENERAL MOTORS CORP.

Install the instrument panel accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (Aztek) in Instrument Panel, Gages and Console.