LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2002 >> Seville SLS >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Power Seat System >> Repair Instructions >> Memory Seat Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the memory seat module (4) to the seat cushion frame.
  2. Install the new rivets (3) to the memory seat module (4) in order to secure the memory seat module to the seat cushion frame.
    Fig 1: Memory Seat Module
    G01797854Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the memory seat module.
  4. Connect the heated seat cushion cover electrical connectors and the wire hold down clips which were removed during disassembly.
    Fig 2: Memory Seat Module Electrical Connector
    G01797855Courtesy of GENERAL MOTORS CORP.
  5. Remove the protective cover from the seat riser.
  6. Install the seat cushion assembly (1) to the seat riser.
    NOTE: Refer to FASTENER NOTICE .
  7. Install the fasteners (2) to the seat cushion assembly (1).
    Fig 3: Front Seat Cushion Assembly
    G01797856Courtesy of GENERAL MOTORS CORP.
  8. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly
    9. Fig 4: Front Seat Cushion Assembly Fasteners
    G01797857Courtesy of GENERAL MOTORS CORP.
  9. Install the front seat cushion assembly rear fasteners (1) to the seat cushion assembly.

    Tighten 

    Tighten the seat cushion assembly fasteners to 9 N.m (80 lb in).

  10. Angle the front seat cushion up, in order to access the front seat cushion assembly fasteners.

    Tighten 

    Tighten the seat cushion assembly fasteners to 9 N.m (80 lb in).

  11. Enable the SIR. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals