Specifications Index
SEVILLE SPECIFICATIONS INDEX
| System | Specifications/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Bearing & Hub Retaining Bolts | 96 Ft. Lbs. (130 N.m) | |
| Battery | SPECIFICATIONS | |
| Brakes | ||
| Bleeding Sequence | RR, LF, LR, RF | |
| Disc Brakes | DISC BRAKE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | GENERATOR SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | BELT ADJUSTMENT | |
| Belt Routing | BELT ROUTING | |
| Engine Cooling | ||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | |
| Radiator Cap Pressure | 15 psi or specification stamped on cap. | |
| Thermostat R & I | THERMOSTAT REPLACEMENT | |
| Water Pump R & I | WATER PUMP REPLACEMENT | |
| Engine Mechanical | ||
| Compression | ENGINE COMPRESSION | |
| Oil Pressure Minumum Pressure at normal operating temperature |
At idle - 5 psi (35 kPa) At 2000 RPM - 35 psi (250 kPa) |
|
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS (LD8 (VIN Y)) ENGINE MECHANICAL SPECIFICATIONS (L37 (VIN 9)) |
|
| Torque | FASTENER TIGHTENING SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | First Pass - 11 Ft. Lbs. (15 N.m) Final Pass - 50 degrees |
|
| Fuel System | ||
| Pressure Specification Ignition key ON and engine OFF |
41-47 psi (283-324 kPa) | |
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST (EXCEPT AURORA & SATURN) | |
| Ignition | ||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Wires (Resistance) | Not equipped with high tension wires. Ignition coils are connected directly to spark plugs by boots. | |
| Ignition Wires (Routing) | N/A | |
| Spark Plug | ||
| Type | AC PT16EPR-C13 | |
| Gap | .050 In. (1.27 mm) | |
| Torque | 13-17 Ft. Lbs. (15 N.m) | |
| Starting | ||
| Starter | STARTER APPLICATION | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | |
| Torque | FASTENER TIGHTENING SPECIFICATIONS | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (140 N.m) | |