LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Ignition Switch/Steering Lock >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Position the steering wheel control switch to the steering wheel.
  2. Connect the electrical connector to the steering wheel control switch.
  3. Install the steering wheel control switch into the steering wheel, ensuring the retaining tabs are fully seated.
    Fig 1: Connecting Electrical Connector To Steering Wheel Control Switch.
    G01455141Courtesy of GENERAL MOTORS CORP.
  4. Install the shroud to the steering wheel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the shroud retaining screws to the steering wheel.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  6. Install the steering wheel. Refer to STEERING WHEEL REPLACEMENT  .
    Fig 2: Installing Shroud Retaining Screws To Back Of Steering Wheel
    G01455142Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals