Normal Mode: Notes

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

This mode can be activated while in any transmission gear position to supply the outlets with 2,400 watts of 120-volt AC power.

To activate the normal mode do the following:

If the system stops supplying 120-volt AC power unexpectedly and the APO button starts flashing, the system has detected an overload or ground fault condition. To reset the system see "Resetting the Short Circuit, Overload or Ground Fault Detection (GFD) Circuit" later in this section.

The APO system will operate in the normal mode until you turn it off by doing one of the following:

Pressing the APO button. The light in the APO button will turn off.
Turning the ignition switch to ACCESSORY or LOCK.