Installation Procedure

WARNING: This page is about a different car, the 2003 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the brake fluid pressure sensor (2) to the EBCM (1).
Tighten

Tighten the brake fluid pressure sensor to 17 N.m (13 lb ft).
Connect the brake fluid pressure sensor electrical connector (3) to the brake fluid pressure sensor (2).
Fill and bleed the hydraulic brake system. Refer to MASTER CYLINDER RESERVOIR FILLING and MANUAL BLEEDING PROCEDURE or PRESSURE BLEEDING PROCEDURE in Hydraulic Brakes.
Perform the Auto Bleed Procedure. Refer to ABS AUTOMATED BLEED PROCEDURE .
Perform the ABS Diagnostic System Check. Refer to DIAGNOSTIC SYSTEM CHECK - ABS .

Fig 1: Brake Fluid Pressure Sensor Electrical Connector
Courtesy of GENERAL MOTORS CORP.