Removal Procedure
WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Thoroughly clean all contaminants from around the EBCM.
- Disconnect the brake fluid pressure sensor electrical connector (3) from the brake fluid pressure sensor (2).
- Remove the brake fluid pressure sensor (2) from the electronic brake control module (EBCM) (1).
IMPORTANT:
The area around the electronic brake control module (EBCM) must be free from loose dirt to prevent contamination of disassembled ABS components.
Fig 1: Identifying Electronic Brake Control Module, Brake Fluid Pressure Sensor & Brake Fluid Pressure Sensor Electrical Connector