LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 659 (Wiper System And Washer System) >> Repair Instructions >> Wiper Motor Module Replacement (LHD) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wiper Transmission View
    GM776830Courtesy of GENERAL MOTORS CORP.
  1. Place the wiper motor module into the vehicle.
  2. Connect the wiper motor module electrical connector (4).
  3. Align the wiper module locator hole (7) to the pin located inside rail of the driver side fender.
  4. Align the locator hole (6) to the hole in the pillar flange.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the outer bolt (5).

    Tighten:  Tighten the outer bolt to 10 N.m (89 lb in).

  6. Install the center bolt (3).

    Tighten:  Tighten the center bolt to 10 N.m (89 lb in).

    7. Fig 2: Removing & Installing Air Inlet Grille
    GM776821Courtesy of GENERAL MOTORS CORP.
  7. Install the air inlet grille (1,3). Refer to Air Inlet Grille Panel Replacement (LHD) or Air Inlet Grille Panel Replacement (RHD) in Body Front End.
  8. Install the wiper arm assemblies. Refer to Wiper Arm Replacement (LHD)  or Wiper Arm Replacement (RHD) .
  9. Install the wiper motor fuses to the underhood fuse block.
scientia non olet · About LEMON Manuals