Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Brake Pipes To Master Cylinder

Courtesy of GENERAL MOTORS CORP.

Turn the ignition switch to the OFF position.
Disconnect the EBCM harness connector.
Remove the BPMV pump motor ground wire.
Remove the brake pipes from the master cylinder to the BPMV (1, 2), noting the location.

Fig 2: Brake Pipes At BPMV To Front Brake Calipers

Courtesy of GENERAL MOTORS CORP.

Remove the brake pipes from the BPMV (1, 2) to the front brake calipers, noting the location.

Fig 3: Brake Pipes At BPMV To Rear Brake Calipers

Courtesy of GENERAL MOTORS CORP.

Remove the brake pipes from the BPMV (1, 2) to the rear brake calipers, noting the location.

Fig 4: Electrical Connector To Brake Fluid Pressure Sensor

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector from the brake fluid pressure sensor (2).
Remove the two insulator nuts (1).
Remove the EBCM/BPMV from the vehicle as one unit.

Fig 5: EBCM To BPMV

Courtesy of GENERAL MOTORS CORP.

Remove the insulator mounting bolt from the EBCM.
Remove the four EBCM to BPMV bolts.
Separate the EBCM from the BPMV by gently pulling apart until separated.
Carefully remove the seal.
The seal may be reused if it is not cut or damaged.