Activating System (Aviator)
- Disconnect and isolate negative battery cable and wait one minute. From under the driver front seat, disconnect the front seat air bag simulator and connect the driver seat 11-pin electrical connector C327.
- Remove the air bag simulator from the driver side safety canopy module electrical connector. Connect the driver side safety canopy module electrical connector. Install the driver side "C" pillar trim panel.
- From under the passenger front seat, disconnect the front seat air bag simulator and connect the passenger seat 11-pin electrical connector C315. Remove the air bag simulator from the passenger side safety canopy module electrical connector.
- Connect the passenger side safety canopy module electrical connector. Install the passenger side "C" pillar trim panel. Remove the air bag simulator from the passenger air bag module electrical connector. Connect the passenger air bag module electrical connector.
- Remove the air bag simulators from the driver air bag module electrical connectors. Install the driver air bag module. Reconnect the battery ground cable. Recheck system operation. Perform SYSTEM OPERATION CHECK .