LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2003 >> Seville SLS >> Repair and Diagnosis >> External Pages >> Different car >> Section 475 (Body Control System) >> Repair Instructions >> Rear Integration Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Integration Module Mounting Bracket & Fasteners
    GM625727Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Before replacing the RIM module, record the personalization settings in order to restore the settings after the new module is installed.
  1. Record the Rear Integration Module (RIM) personalization settings. Refer to Driver Personalization in Personalization.
  2. Remove the rear storage compartment trim. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
  3. Remove the electrical component mounting panel nuts (2).
  4. Pull the electrical component mounting panel (1) away from the body and place the panel (1) module side up in the rear compartment.
    5. Fig 2: Removing Of RIM
    GM650998Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the RIM electrical connectors.
  6. Remove the RIM (1) by depressing the locking tabs (2) inward, in order to release the RIM (1) from the electrical component mounting panel.
scientia non olet · About LEMON Manuals