LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis (Single Page) >> Body & Frame >> Ignition Switch/Steering Lock >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the wire harness to the steering wheel control switch assembly.
    2. Fig 1: Aligning Control Switch Assembly Engagement Tabs To Steering Wheel
    GM803005Courtesy of GENERAL MOTORS CORP.
  2. Align the control switch assembly engagement tabs to the steering wheel.

    Push in on the control switch assembly in order to secure the assembly to the steering wheel.

    3. Fig 2: Installing Control Harness Retainer And Screw
    GM803006Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the control harness retainer and screw.

    Tighten:  Tighten the screw to 2.3 N.m (20 lb in).

  4. Install the control switch assembly screws

    Tighten:  Tighten the screws to 2.3 N.m (20 lb in).

    5. Fig 3: Connecting Electrical Connector To Steering Wheel Control
    GM754855Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector to the steering wheel control.
  6. Secure the connector to the retaining clip.
  7. Install the inflatable restraint module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  8. Enable the SIR. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals