Navigation System

To program a name use the following procedure:

1. Press the button with the dot on it located to the right of the display that is next to the EDIT prompt. This will open the EDIT menu. You will see an alphabet at the bottom of the display and a blank line with a blinking cursor.
2. Scroll to the first letter you want to highlight.
3. Press the scroll/select knob once to select the letter. The letter will then appear on the line above the alphabet.
4. Repeat steps 2 and 3 until the name you want is complete.
5. Press the button with the dot on it located to the right of the display that is next to the Back prompt to exit and set your choice.
6. The name you selected is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available.