July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

Install the KS.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: View Of Right Knock Sensor & Bolt

GM860801

Courtesy of GENERAL MOTORS CORP.

Install the KS bolt.
Tighten: Tighten the KS bolt to 23 N.m (17 lb ft).

Fig 2: View Of Right Knock Sensor And Electrical Connector

GM945742

Courtesy of GENERAL MOTORS CORP.

Install the KS electrical connector.
Install the wiring harness heat shield to the original position.
Lower the vehicle.