LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2004 >> DeVille Protection Series >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4T80-E (Introduction, Service & Replacement) >> Repair Instructions >> Shift Control Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Shifter Assembly & Fasteners
    GM291888Courtesy of GENERAL MOTORS CORP.
  1. Install the shifter assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the shifter fasteners.

    Tighten:  Tighten the shifter fasteners to 9 N.m (79 lb in).

    3. Fig 2: View Of Shift Cable Terminal & Shifter Pin
    GM291754Courtesy of GENERAL MOTORS CORP.
  3. Insert the shift cable onto the shifter control.
  4. Connect the automatic transmission shift lock solenoid wire harness connector.
  5. Adjust the shift cable as follows.
    1. Place the shifter into the N (neutral) position.
    2. Loosen the shifter adjuster nut.
    3. Tighten the adjuster nut.

      Tighten:  Tighten the adjuster nut to 25 N.m (18 lb ft).

    6. Fig 3: View Of Console Trim Plate
    GM105570Courtesy of GENERAL MOTORS CORP.
  6. Install the console trim plate (1). Refer to Trim Plate Replacement - Front Floor Console (DTS) in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals