Installation Procedure
- Install the cable clips (1) to the A-pillar.
- Connect the electrical wire connector (4).
- Connect the cable (3) to the radio.
- Install the cable clips (1) to the roof.
- Connect the cable (2) to the radio antenna module.
- Connect the wire connector to the radio antenna module.
- Install the bolt retaining the radio antenna module to the roof.
Tighten: Tighten the retaining bolt to 9 N.m (80 lb in).
- Install the headliner. Refer to Headliner Replacement in Interior Trim.
- Install the I/P trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.