Power Windows Inoperative - Lockout Function
Power Windows Inoperative - Lockout Function
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Power Window Schematics Connector End View Reference: Power Door Systems Connector End Views |
|||
| 1 | Did you perform the Door Systems Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Door Systems |
| 2 |
|
Go to Step 3 | Go to Power Window Inoperative - Passenger Door (Front Door) or Power Window Inoperative - Passenger Door (Rear Door(s)) |
| 3 |
|
Go to Step 4 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 4 |
|
Go to Step 5 | Go to Step 10 |
| 5 | Does the window lockout function for the front passenger power window operate properly? | Go to Step 6 | Go to Step 9 |
| 6 |
|
Go to Step 7 | Go to Step 11 |
| 7 | Test for a short to battery positive voltage on the rear window lockout signal circuit. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 16 | Go to Step 8 |
| 8 | Inspect for poor connections at the body control module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 16 | Go to Step 12 |
| 9 | Inspect for poor connections at the passenger door module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 16 | Go to Step 13 |
| 10 | Inspect for poor connections at the driver door module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 16 | Go to Step 14 |
| 11 | Inspect for poor connections at the rear power window switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 16 | Go to Step 15 |
| 12 |
IMPORTANT:
Perform the set up procedure for the body control module. Refer to Body Control Module (BCM) Programming/RPO Configuration
in Body Control System. Replace the body control module. Refer to Body Control Module Replacement
in Body Control System.Did you complete the replacement? |
Go to Step 16 | - |
| 13 |
IMPORTANT:
Perform the set up procedure for the passenger door module. Refer to Service Programming System (SPS)
in Programming. Replace the passenger door module. Refer to Switch Replacement - Door Lock and Side Window - Passenger .Did you complete the repair? |
Go to Step 16 | - |
| 14 |
IMPORTANT:
Perform the set up procedure for the driver door module. Refer to Service Programming System (SPS)
in Programming. Replace the driver door module. Refer to Switch Replacement - Door Lock and Side Window - Driver .Did you complete the repair? |
Go to Step 16 | - |
| 15 | Replace the rear power window switch. Refer to Power Window Switch Replacement - Rear Door . Did you complete the repair? |
Go to Step 16 | - |
| 16 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |