Installation Procedure

IMPORTANT:

Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

Fig 1: Removing/Installing EBCM (w/ JL4)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the new EBCM screws (1).
Tighten: Tighten the screws to 5 N.m (39 lb in) in an X-pattern.

Fig 2: Exploded View Of EBCM & BPMV Components (w/ JL4)

Courtesy of GENERAL MOTORS CORP.

Lower the vehicle.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
Revise the tire calibration using the Scan Tool Tire Size Calibration function.
Return to Diagnostic Starting Point - Antilock Brake System .