LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2004 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 413 (Engine Control System - 8.1L (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Yukon XL, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Lubricate the port of the MAP sensor with clean engine oil. Avoid dipping the sensor port directly into the lubricant or using a solid type of lubricant, as they may block the vacuum port signal.
    Fig 1: View Of MAP Sensor & Bolt
    GM858207Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the MAP sensor.
  2. Install the MAP sensor bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

    3. Fig 2: View Of Ignition Coil, ECT And MAP Sensor Electrical Connectors
    GM750529Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAP sensor electrical connector (1).
  4. Install the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
scientia non olet · About LEMON Manuals