LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2004 >> XLR >> Repair and Diagnosis (Single Page) >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Clean the BPMV seal surface with alcohol using a clean rag.
    2. Fig 1: View Of EBCM, BPMV & Bolts
    GM143452Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EBCM to the BPMV.
  3. Tighten the four mounting bolts in the following sequence:

    Tighten: 

    • First pass to 3 N.m (27 lb in).
    • Second pass to 6 N.m (53 lb in).

  4. Connect the EBCM connector.
  5. Connect the brake fluid pressure sensor connector.
    6. Fig 2: View Of EBCM Connector, Bracket & Bolts
    GM1274761Courtesy of GENERAL MOTORS CORP.
  6. Install the two BPMV bracket bolts.

    Tighten:  Tighten the bolt to 27 N.m (20 lb ft).

  7. Lower the vehicle.
  8. Turn the ignition switch to the ON position, engine off.
  9. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals