Removal Procedure
- Turn the ignition switch to the OFF position.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
in Engine Electrical.
- Disconnect the brake fluid pressure sensor connector.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle
in General Information.
- Remove the two bracket bolts.
Courtesy of GENERAL MOTORS CORP.
- Disconnect the electronic brake control module (EBCM) connector.
Courtesy of GENERAL MOTORS CORP.
- Remove the four EBCM to brake pressure modulator valve (BPMV) bolts.
- Separate the EBCM from the BPMV by gently pulling apart until separated.