Scan Tool Data Definitions (Disengage History)

WARNING: This page is about a different car, the 2004 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The following data list terms MAY NOT apply to all vehicle lines.

ABS: Anti-lock Brake (ABS) is active.
Active Brake Yaw: A Class 2 message is received by the PCM that the Brake Yaw is active.
ALDL: A scan tool message to inhibit cruise control operation is received by the PCM.
Brake: A class 2 message is received by the PCM that a basic brake problem has occurred. The PCM senses any brake active operation.
Battery Voltage: The battery positive voltage is out of range.
Clutch Switch: A failure of the clutch switch has been detected.
CC Cancel Switch: A class 2 message is received by the PCM that a cruise cancel event has occurred.
CC Inhibit Circuit: A fault on the cruise control inhibit signal circuit has been detected.
Delta Vehicle Speed: The vehicle speed is greater or less than the cruise control operating criteria speed.
Engine Not Running: The engine is not running
Engine Run Time: The engine run time does not equal the cruise control enable criteria run time.
Engine Speed: The vehicle speed is greater or less than the cruise control enable criteria speed.
Injector: Any number of injectors are disabled by high mph.
Manual/Neutral CC: The vehicle is shifted into neutral while cruise control is in operation.
MPH Limited: The mph is limited, by the PCM controlling the fuel and electronic spark timing.
P0751: 1-2 shift solenoid valve performance.
P0753: 1-2 shift solenoid control circuit fault.
P0756: 2-3 shift solenoid valve performance.
P0758: 2-3 shift solenoid control circuit fault.
P0785: 3-2 shift solenoid control circuit fault.
Park Brake Active: A Class 2 message is received by the PCM that the parking brake is active.
Serial Communications: A class 2 serial communication problem is detected.
SMCC Fault: A fault is detected with the stepper motor cruise control module.
TCS: The traction control is active.
Trans: The clutch pedal is pressed on a manual transmission vehicle or when the gear selector is shifted out of DRIVE during cruise control operation.
Vehicle Speed Fault: A problem is detected with vehicle speed.
Vehicle Speed: The vehicle speed drops below the cruise control engaged criteria.