Installation Procedure
WARNING: This page is about a different car, the 2005 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the seal surface of the BPMV.
- Install the EBCM (1) to the BPMV (2).
- Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
- Install the 2 upper NEW EBCM to BPMV screws.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Install the 2 lower NEW EBCM to BPMV screws.
Tighten: Tighten the (4) NEW EBCM to BPMV screws in sequence (1-4) to 5 N.m (44 lb in).
- Install the front air deflector. Refer to Air Deflector Replacement - Front in Body Front End.
- Lower the vehicle.
- Connect the EBCM electrical connector (1) to the EBCM (3).
- Rotate the EBCM connector tab (2) to the locked position.
- Use the scan tool in order to clear the DTCs.
- Perform the auto bleed procedure. Refer to ABS Automated Bleed Procedure .
- If installing a new EBCM it is necessary to program the EBCM. Refer to Service Programming System (SPS) in Programming and Setup.
- Perform the System Check-Vehicle. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
- Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Replacement in Lighting Systems.
IMPORTANT:
Use New EBCM/BPMV screws after separating the EBCM from the BPMV.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
NOTE:
To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.