Installation Procedure
WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the TAC module.
- Install the TAC module nuts.
Tighten: Tighten the nuts to 9 N.m (80 lb in).
- Connect the engine wiring harness electrical connector (1).
- Connect the I/P wiring harness electrical connector (2).
- Install the CPA retainer (1).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.