Barometric Pressure Sensor: Service and Repair

BAROMETRIC PRESSURE (BARO) SENSOR REPLACEMENT

REMOVAL PROCEDURE




- Turn the ignition OFF.
- Remove the fuel injector sight shield.
- Disconnect the barometric pressure (BARO) sensor electrical connector.




- Remove the BARO sensor bolt.
- Remove the BARO sensor.

INSTALLATION PROCEDURE




- Install the BARO sensor.
- Install the BARO sensor bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the sensor bolt to 10 N.m (89 lb in).




- Connect the BARO sensor electrical connector.
- Install the fuel injector sight shield.