LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2005 >> STS V6-3.6L VIN 7 >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Body Control Module >> Testing and Inspection >> Scan Tool Testing and Procedures >> Scan Tool Data Definitions
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Scan Tool Data Definitions




SCAN TOOL DATA DEFINITIONS

INSTRUMENT PANEL MODULE (IPM)
Steering Wheel Controls Return: The scan tool displays the number of counts corresponding to the signal of the switch pressed.

Battery Voltage Signal: The scan tool displays the battery voltage. The battery voltage input represents the system voltage measured at the module ignition feed input.

Accessory, Run, or Run/Crank Relay Status: The scan tool displays the status of the respective relay.

Start, Accessory, or OFF LED Duty Cycle: The scan tool displays the percentage of the PWM control signal of the respective LED.

REAR INTEGRATION MODULE (RIM)
Battery Voltage Signal: The scan tool displays the battery voltage. The battery voltage input represents the system voltage measured at the module ignition feed input.

Run/Crank Terminal Status: The scan tool displays the status of the respective input.

Sunroof Enable Command: The scan tool displays the status of the respective output.

REMOTE CONTROL DOOR LOCK RECEIVER (RCDLR)
Battery Voltage Signal: The scan tool displays the battery voltage. The battery voltage input represents the system voltage measured at the module ignition feed input.

Ignition Mode Switch: The scan tool displays the voltage and the state read by the module from the ignition mode switch.

Ign. Mode Sw. Dimming Command: The scan tool displays the status of the ignition mode switch dimming.

Ignition Switch Fault: The scan tool displays if the remote control door lock receiver (RCDLR) detected a fault on the ignition mode switch signal circuit.

Invalid Power Moding: The scan tool displays if the RCDLR detects an invalid power moding.

Back up Power Moding: The scan tool displays if back up power mode is active or not.

Run/Crank Relay Command: The scan tool displays if the run/crank relay is controlled or not by the module.

Run/Crank Relay Status: The scan tool displays the run/crank relay status.

DRIVER/PASSENGER DOOR MODULE (DDM/PDM)
Door Ajar Switch: The scan tool displays the status of the respective door switch.
scientia non olet · About LEMON Manuals