LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2005 >> XLR >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Transmission Control Module (TCM) Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the transmission control module (TCM) to the engine control module (ECM) bracket.
  2. Install the transmission control module (TCM) fasteners to the bracket.

    Tighten:  Tighten the fasteners to 15 N.m (11 lb ft).

  3. Connect the electrical connector to the transmission control module (TCM).
  4. Install the engine control module (ECM) bracket.
  5. Install the engine control module (ECM) bracket fasteners.

    Tighten:  Tighten the fasteners to 15 N.m (11 lb ft).

  6. Install the wheelhouse panel. Refer to Wheelhouse Filler Replacement in Body Front End.
  7. If a new TCM is being installed, program the ECM. Refer to Service Programming System (SPS) in Programming.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals