LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2005 >> XLR >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Installation Procedure

  1. Clean the BPMV seal surface with alcohol using a clean rag.
    2. Fig 1: View Of EBCM, BPMV & Bolts
    GM143452Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EBCM to the BPMV.
  3. Tighten the four mounting bolts in the following sequence:

    Tighten: 

    • First pass to 3 N.m (27 lb in).
    • Second pass to 6 N.m (53 lb in).

  4. Connect the EBCM connector.
  5. Connect the brake fluid pressure sensor connector.
    6. Fig 2: View Of EBCM Connector, Bracket & Bolts
    GM1274761Courtesy of GENERAL MOTORS CORP.
  6. Install the two BPMV bracket bolts.

    Tighten:  Tighten the bolt to 27 N.m (20 lb ft).

  7. Lower the vehicle.
  8. Turn the ignition switch to the ON position, engine off.
  9. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals