Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing & Installing Amplifier

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors.
Install the amplifier to the studs on the wheel house.
NOTE: Refer to Fastener Notice .
Install the nuts securing the amplifier the vehicle.
Tighten: Tighten the nuts to 9 N.m (80 lb in).
Reinstall the rear compartment trim. Refer to Rear Compartment Trim Panel Replacement .
Refer to Control Module References for programming and setup information.