Base Audio System

To enter the Feature programming mode use the following procedure:

1. If the vehicle has memory settings, press the appropriate memory button, 1 or 2, located on the driver door armrest. The driver information center (DIC) display will show either Driver 1 or 2 depending on which button was selected.
2. Turn the ignition to ON without the engine running. Make sure an automatic transmission is in PARK (P) or a manual transmission has the parking brake set.
3. Press the scroll/select knob once to access the main menu of the DIC.
4. Turn the scroll/select knob until SETUP is highlighted.
5. Press the scroll/select knob once to access the SETUP menu.
6. Scroll to the PERSONALIZATION menu item and select it to access the PERSONALIZATION menu.
7. Press the scroll/select knob until a check mark appears after the PERSONALIZATION menu item. This turns on the personalization feature. If you see a minus sign (-) after the PERSONALIZATION menu item, the personalization feature has been turned off.

To program a name use the following procedure:

1. Select the PERSONALIZATION NAME menu item by pressing the scroll/select knob once. You will see a blinking cursor.
2. Turn the scroll/select knob until you reach the first letter you want to highlight. There is a complete alphabet with both upper and lower case letters and numbers zero through nine. Also included are spaces and other non-letter characters such as the ampersand (&).
3. Press the scroll/select knob once to select the letter. The letter will then appear on the display. If you make a mistake, press the back key this will exit the menu. You can then go back into the menu and edit the name.
4. Repeat steps 2 and 3 until the name you want is complete. You can program up to 26 characters.
5. Press the BACK button located to the lower right of the display to exit and set your choice.