Procedures

INTAKE MANIFOLD RUNNER CONTROL SOLENOID REPLACEMENT

REMOVAL PROCEDURE




- Remove the upper intake manifold with the lower intake manifold.

IMPORTANT: DO NOT separate the upper intake manifold from the lower intake manifold.

- Remove the intake manifold runner control solenoid bolts.
- Remove the intake manifold runner control solenoid.

INSTALLATION PROCEDURE




- Install the intake manifold runner control solenoid.
- Install the intake manifold runner control solenoid bolts.

NOTE: Refer to Fastener Notice.

Tighten the intake manifold runner control solenoid bolts to 10 Nm (89 lb in).

- Install the upper intake manifold.