LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2006 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 2046 (Object Detection System - Park Assist System) >> Diagnostic Information and Procedures >> Parking Assist System Malfunction >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Park Assist Disable Switch Circuit Malfunction

  1. Ignition OFF, disconnect the harness connector at the I/P multifunction switch.
  2. Test for less than 10 Ω between the appropriate ground circuit terminal listed below and ground.
    • X88/Z88 terminal 3
    • Z75 terminal 5
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool Park Assist Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the object alarm module.
  4. Install a 3A fused jumper wire between the signal circuit terminal 2 and ground. Verify the scan tool Park Assist Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the object alarm module.
  5. If all circuits test normal, test or replace the I/P multifunction switch.

Park Assist Disable LED Circuit Malfunction

  1. Ignition OFF, disconnect the harness connector at the I/P multifunction switch.
  2. Ignition ON, verify a test lamp illuminates between the appropriate ignition circuit terminal listed below and ground.
    • X88/Z88 terminal 6
    • Z75 terminal 4
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  3. Ignition OFF, connect the harness connector at the I/P multifunction switch. Disconnect the X1 harness connector at the object alarm module.
  4. Ignition ON, verify the park assist disable LED is not illuminate.
    • If the LED is illuminated, test the control circuit for a short to ground. If the circuit tests normal, test or replace the I/P multifunction switch.
  5. Install a 10A fused jumper wire between the control circuit terminal 3 and ground. Verify the park assist disable LED is illuminated.
    • If the LED is not illuminated, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the I/P multifunction switch.
  6. If all circuits test normal, replace the object alarm module.
scientia non olet · About LEMON Manuals