LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2006 >> Escalade EXT >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Adjustable Pedal System >> Repair Instructions >> Adjustable Accelerator Pedal Bracket Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    IMPORTANT: Ensure the brake pedal assembly is adjusted to the lowest position farthest from the drivers seat prior to removal of the accelerator assembly. Failure to do so could result in incorrect step-over height between the brake and accelerator pedals and improper function of the adjustable pedal system.
  1. Disconnect the adjustable pedal motor electrical connector.
  2. Remove the accelerator pedal assembly. Refer to Accelerator Pedal Assembly Replacement .
  3. Remove the accelerator pedal bracket nuts.
  4. Remove the accelerator pedal harness from the accelerator pedal bracket.
  5. Remove the adjustable pedal drive cable from the accelerator pedal actuator using the following procedure:
    1. Twist the cable housing counterclockwise.
    2. Using needle nose pliers or equivalent, compress the secondary locking tabs located below the twist and lock tabs and remove the cable from the pedal actuator.
  6. Remove the accelerator mounting nuts from the accelerator bracket.
  7. Remove the accelerator actuator lower pivot pin retaining push nut.
  8. Remove the accelerator actuator lower pivot pin.
  9. Remove the accelerator actuator mounting screws.
  10. Remove the accelerator actuator.
scientia non olet · About LEMON Manuals