Scan Tool Output Controls (W/NW7)

Scan Tool Output Control	Additional Menu Selections	Description
Refer to the scan tool manual for complete scan tool operating instructions.
ABS Motor	-	This function allows the technician to command the ABS pump motor ON and OFF.
Automated Bleed	-	The electronic brake control module (EBCM) commands each valve solenoid and the pump motor ON and OFF in a special sequence in order to bleed air out of the brake pressure modulator valve (BPMV). Refer to ABS Automated Bleed Procedure (w/o JL4) or ABS Automated Bleed Procedure (W/JL4) for a step-by-step procedure.
Function Test	-	The EBCM commands the system relay, valve solenoids and pump motor ON and OFF. The EBCM sets a DTC if a malfunction is detected.
Solenoid Tests	Left Front Dump Valve Left Front Isolation Valve Rear Dump Valve Rear Isolation Valve Right Front Dump Valve Right Front Isolation Valve	This function allows the technician to command a selected dump or isolation valve solenoid ON and OFF to verify proper operation of the BPMV. Refer to Brake Pressure Modulator Valve Hydraulic Testing for complete procedure instructions.
System Identification	-	The scan tool displays the hardware and software revision of the EBCM.
Tire Size Calibration	Read Tire Calibration New Tire Size	IMPORTANT: The powertrain control module (PCM) must also be programmed with the correct tire size calibration when different size tires are installed on the vehicle. Refer to Service Programming System (SPS) . This function allows the technician to read the tire size calibration of the EBCM or calibrate the EBCM to the correct tire size. Calibration must be performed when the EBCM is replaced or when different size tires are installed on the vehicle.
Low TRAC Lamp	-	This function allows the technician to command the low traction indicator ON and OFF.
Traction Off Lamp	-	This function allows the technician to command the traction OFF indicator ON and OFF.
Requested Torque	-	This function allows the technician to turn OFF engine torque reduction in order to verify proper operation of the traction control system (TCS).