LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2006 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1365 (Data Communication System) >> Diagnostic Information and Procedures >> DTC U1862 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector X2 at the SDGM.
    2. IMPORTANT: The scan tool must be disconnected and the ignition key must be out of the ignition switch for 30 seconds for proper test results.
  2. Test for less than 10 ohms between the ground circuit terminal 18 and B+.
    • If greater than the specified range, test the circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 8 and ground.
    • If the test lamp does not illuminate, test the circuit for a short to ground or an open/high resistance.
  4. Ignition ON, verify that a test lamp illuminates between the enable signal circuit terminal 16 and ground.
    • If the test lamp does not illuminate, test the circuit for an open/high resistance.
  5. If all circuits test normal, replace the SDGM.
scientia non olet · About LEMON Manuals