Power Steering Gear Inlet Pipe/Hose Replacement (Gas Without Hydroboost): Notes

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Power Steering Gear Inlet Pipe/Hose (Gas Without Hydroboost)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the engine shield. Refer to Engine Shield Replacement .
1	Power Steering Gear Inlet Hose Fitting CAUTION: Refer to Fastener Caution . Procedure Remove as much power steering fluid from the power steering fluid reservoir as possible. Place drain pans under the vehicle as needed. Tighten: 32 N.m (24 lb ft)
2	Power Steering Gear Inlet Hose Retaining Plate Bolt Tighten: 12 N.m (106 lb in)
3	Power Steering Gear Inlet Hose CAUTION: Refer to Power Steering Hose Disconnected Caution . Procedure Use the remover/installer J 44586 to replace the steering gear seals if necessary. See Special Tools . Fill and bleed the power steering system. Refer to Power Steering System Bleeding . Tip: Note the routing of the power steering gear inlet hose to ensure proper installation. Keep all open connections in the power steering system clean and free of debris.