LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2006 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1749 (Power Take-Off System) >> Diagnostic Information and Procedures >> DTC P0651 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at X124.
  2. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal E at the female side of the connector and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the PTO module.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the PTO module.
  3. Ignition ON, test for 0 volts between the 5-volt reference circuit terminal E at the male side of the connector and ground.
    • If greater than the specified value, test the 5-volt reference circuit between X124 and the upfitted remote PTO switch assembly for a short to voltage. If the circuit tests normal, test or replace the upfitted remote PTO switch assembly.
  4. Ignition OFF, test for infinite resistance between the 5-volt reference circuit terminal E at the male side of the connector and ground.
    • If less than the specified value, test the 5-volt reference circuit for a short to ground. If the circuit tests normal, test or replace the upfitted remote PTO switch assembly.
  5. If all circuits test normal, replace the PTO module.
scientia non olet · About LEMON Manuals