Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing & Installing Receiver

Courtesy of GENERAL MOTORS CORP.

Install the receiver to the rear carrier.

NOTE: Refer to Fastener Notice .

Install the fasteners securing the receiver to the rear carrier.
Tighten: Tighten the fasteners to 2 N.m (17 lb in).
Connect the electrical connectors.
Install the rear self panel. Refer to Trim Panel Replacement - Rear Window Shelf .
Perform the setup procedure for the digital radio receiver. Refer to Control Module References for programming and setup information.