Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the MAF sensor.
- Ignition OFF, test for less than 5 ohms of resistance between the ground circuit terminal B and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, test for 4.8-5.2 volts between the MAF sensor signal circuit terminal A and ground.
- If less than the specified range, test the MAF sensor signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the control module.
- If greater than the specified range, test the MAF sensor signal circuit for a short to voltage. If the circuit tests normal, replace the control module.
- Ignition ON, verify that a test lamp illuminates between the MAF sensor ignition 1 voltage circuit terminal C and ground.
- If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
- Connect the J 38522 to the vehicle. Refer to Component Testing.