Circuit/System Verification
IMPORTANT:
- Perform this verification procedure only when the ignition has been OFF for 8 hours or more.
- The IAT will begin to warm up as soon as the ignition key is turned ON
- Ignition ON, observe the scan tool IAT Sensor, IAT Sensor 2, and ECT Sensor parameters. The readings should be within 15°C (27°F) of each other and also the ambient temperature.
- Engine running, observe the DTC information with a scan tool. DTCs P0112 or P0113 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.