Circuit/System Verification
- If DTC P0112, P0113, P0116, P0117, P0118, P0197, or P0198 are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Ignition ON, observe the scan tool Engine Oil Temperature Calculated and the Engine Oil Temperature Sensor parameters. The readings should be within 30°C (54°F) of each other.
- Ignition ON, observe the scan tool IAT Sensor, ECT Sensor, and Engine Oil Temperature Sensor parameters. The readings should be within 15°C (27°F) of each other and also the ambient temperature.
- Engine running, observe the DTC information with a scan tool. DTC P0196 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
IMPORTANT:
Perform the following verification procedure only if the ignition has been OFF for 10 hours or more.