Circuit/System Verification
- Turn OFF the ignition.
- Relieve the fuel pressure. Refer to Fuel Pressure Relief
.
- Disconnect the chassis fuel hose from the fuel rail. Refer to Metal Collar Quick Connect Fitting Service
.
- Install the J 37287
between the chassis fuel hose and the fuel rail.
- Open the valve on the J 37287
.
- Turn ON the ignition, with the engine OFF.
- Command the fuel pump relay ON with a scan tool.
- Bleed the air from the J 34730-1A
.
- Command the fuel pump relay ON and then OFF with a scan tool.
- Close the fuel feed pipe shut-off valve.
- Monitor the J 34730-1A
for one minute.
- If the fuel pressure remains constant, replace the fuel sender assembly.
- If the fuel pressure does not remain constant, locate and replace the leaking fuel injectors.