Suspension Position Sensor Replacement
WARNING: This page is about a different car, the 2007 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
If a position sensor is replaced, the following must be performed:
IMPORTANT:
The vehicle must be at correct trim height and on a level surface before performing trimset procedure. Refer to Trim Height Inspection
in General Suspension Diagnosis. Connect scan tool to the vehicle, turn the ignition ON, with the engine OFF and follow the on screen instruction in ESC Special functions.
Trimset procedure. Ignition ON, using a scan tool follow the on screen instructions under special functions.