LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> CTS Base, 2.8 T, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 763 (Keyless Entry System And Remote Functions) >> Diagnostic Information and Procedures >> DTC B3124 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2013 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the headline antenna.
  2. Place a valid keyless entry transmitter in the pocket located in the center console.
  3. Ignition ON, verify a test lamp does not illuminate between the signal circuit terminal A and ground.
    • If the test lamp illuminates, test the signal circuit for a short to voltage. If the circuit tests normal, replace the RCDLR.
  4. Connect a DMM, set to capture AC voltage using the MIN MAX function, between the signal circuit terminal A and the low reference circuit terminal B.
  5. Attempt to start the vehicle. Verify the DMM captured an AC voltage signal.
    • If an AC voltage was not captured, test the signal circuit and the low reference circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the RCDLR.
  6. If all circuits test normal, test or replace the headliner antenna.
scientia non olet · About LEMON Manuals