LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> CTS Base, 3.6 7, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 332 (Cellular System, Entertainment System, And Navigation System) >> Diagnostic Information and Procedures >> Radio Poor Reception >> Antenna System Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Antenna System Test

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Always zero out the DMM before taking a resistance measurement in order to ensure an accurate reading.
  1. Disconnect the negative battery cable.
  2. Disconnect the antenna lead-in connector from the radio receiver.
  3. Measure the resistance from the negative battery cable to the coax outer conductor connector.
  4. The resistance measured should be 0.20 ohms or less.
  5. Test the following when the resistance is greater than 0.20 ohms.
    • The coaxial cable interconnects for a poor connection or corrosion.
    • Test for an open or high resistance from the battery negative cable to the body. Refer to Circuit Testing and Wiring Repairs .
  6. After finding and correcting the condition, operate the system in order to verify the repair.

Perform the Antenna Checking Procedures after confirming the integrity of the antenna ground.