Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice .

Install the mounting bracket to the radio and secure with the retaining bolts.
Tighten: Tighten the bolts to 2.5 N.m (22 lb in).
Connect the electrical/audio and coaxial cable connectors to the radio control.
Install the radio control into position in the I/P center support bracket.
Align the radio control locator tab into the center support bracket locator hole.

Fig 1: View Of Radio Control & Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the radio control retaining screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
Install the RDO/CD MiniFuse® #5 to the I/P electrical center.
Install the cover to the I/P electrical center.
Refer to Control Module References for programming and setup information.