LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> CTS Base, 3.6 7, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Programming And Setup - All Systems) >> Repair Instructions >> Electronic Suspension Control Module Programming and Setup >> Suspension Position Sensor Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Suspension Position Sensor Replacement

WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

If a position sensor is replaced, the procedures must be performed in the following order:

  1. The bumpstop setup procedure. To perform this procedure, lift the vehicle just off the ground to fully extend the suspension. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instructions in ESC Special Functions.
    IMPORTANT: The vehicle must be at correct trim height and on a level surface before performing trimset procedure. Refer to Trim Height Inspection .
  2. The trimset procedure. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instruction in the ESC Special functions.
scientia non olet · About LEMON Manuals