LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> CTS V >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Memory Modules >> Secondary And Configurable Customer Controls >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the wire harness to the steering wheel control switch assembly.
    2. Fig 1: Securing Control Switch Assembly To Steering Wheel
    GM803005Courtesy of GENERAL MOTORS CORP.
  2. Align the control switch assembly engagement tabs to the steering wheel.

    Push in on the control switch assembly in order to secure the assembly to the steering wheel.

    3. Fig 2: View Of Steering Wheel Control Switch Retaining Screws
    GM803006Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the control harness retainer and screw.

    Tighten:  Tighten the screw to 2.3 N.m (20 lb in).

  4. Install the control switch assembly screws

    Tighten:  Tighten the screws to 2.3 N.m (20 lb in).

    5. Fig 3: View Of Steering Wheel Control Switch Electrical Connector
    GM754855Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector to the steering wheel control.
  6. Secure the connector to the retaining clip.
  7. Install the inflatable restraint module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  8. Enable the SIR. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals