Installation Procedure

Fig 1: View Of EBCM & BPMV

Courtesy of GENERAL MOTORS CORP.

Clean the seal surface of the BPMV.
Install the EBCM (1) to the BPMV (2).
Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
Install the 2 upper EBCM to BPMV screws.
Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 2: Installing EBCM To BPMV Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the 2 lower EBCM to BPMV screws.
Tighten: Tighten the (4) EBCM to BPMV screws in sequence (1-4) to 5 N.m (44 lb in).
Install the front air deflector. Refer to Front Air Deflector Replacement .
Lower the vehicle.

Fig 3: View Of EBCM And Electrical Connector

Courtesy of GENERAL MOTORS CORP.

NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.

Connect the EBCM electrical connector (1) to the EBCM (3).
Rotate the EBCM connector tab (2) to the locked position.
Use the scan tool in order to clear the DTCs.
If installing a new EBCM, program the EBCM. Refer to Control Module References .
Perform the Diagnostic System Check - Vehicle. Refer to Diagnostic System Check - Vehicle .
Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .